DC Motor Driver

June 2, 2017

evive has a dedicated pair of DC Motor Driver pin outputs, which can be used when the user has to connect a large motor which draws current more than 1 Amp.

The pin configuration from left to right is:

GND
VVR
PWM Pin (For channel 1, connected to digital pin 44 to evive, and for channel 2, connected to digital pin 45)
Direction Pin 1 (For channel 1, connected to digital pin 28 to evive, and for channel 2, connected to digital pin 30)
Direction Pin 1 (For channel 1, connected to digital pin 29 to evive, and for channel 2, connected to digital pin 31)

Share this Documentation

DC Motor

Introduction evive has two inbuilt motor control units with which you can control motors with…

How to interface DC motor with Arduino IDE

This tutorial discusses what are DC motors, how to control them, and how to interface them with Arduino IDE using motor control units in evive with the help of an Arduino IDE sketch.

run motor () in direction () with speed () %

The block takes the motor port, the direction of rotation (forward or reverse) and speed of rotation (between 0 to 100 %) as input from the user and rotates the motor accordingly.