#3060

dhrupal93
Keymaster

My Achievements

Add Your Friend IconFirst Login Icon

Hi @chris
So the potentiometer test code is running fine as the LED on Pin 13 is blinking as we move the Pot 1 (connected to A9 in evive. Since we are not using the TFT (as we have not wrote any code for that yet), it will be idle (grey or show history). Once, we load the program in evive/Arduino and device is powered, it will just start running continuously. As we power the micro-controller in evive, firstly the Arduino’s Setup function will run for one time and then it will continuously run loop function (forever in general sense). If we upload any other code, the previous one will get erased and the new one will be stored there (in Flash Memory).

To load back evive’s firmware, you need to upload the firmware [find here] again.

Also have a look at the documentation of  loading multiple user programs and run as and when required.
http://thestempedia.com/evive-documentation/menu-interface/user-defined-functions/  (Please give us feedback on ease of doing this or if u wanna contribute some better user friendly way)

Close Menu
×

Cart