Tutorial and Project Tag: Servo

Projects

DIY Mini Safe Locker Using Servo

DIY Mini Safe Locker Using Servo

Make your own DIY mini-safe locker using components from the evive Starter Kit and control it using evive’s slide switch!

DIY Color-Sorter-STEAM-project

DIY Color Sorter

This project will show you how to make a DIY color sorter using IR sensors and a servo motor.

Smart-Trash-Bin

DIY Smart Trash Bin

This project will show you how to make a DIY Smart Trash Bin.

Claw-Machine

DIY Candy Claw Machine

This project will show you how to make your own DIY Candy Claw Machine.

Archery-Robot_1

DIY Archery Robot

This project will show you how to make an archery robot.

DIY Smart Rat Tracker

DIY Smart Rat Trapper

This project teaches you how to make a simple, yet smart DIY rat trap that no rat can ever escape.

Sun Tracker

DIY Solar Tracker

Learn how to make a light tracker of your own that always points in the direction of the light falling on it.

Tutorials

evive-Plug-and-Play-Part-1

evive – Plug and Play: Part 1

In this tutorial, we are going to give you a hands-on experience of evive’s plug and play interface through activities for controlling a DC motor, a servo motor, understanding the inbuilt touch sensors of evive.
Getting Started With Servo Motor

What is a Servo Motor?

Learn what is servo motor, how does servo motor work, interface it with evive using PictoBlox and what projects to make using a servo.
controlling gripper

How to interface Servo Motor with Arduino IDE

This tutorial discusses what are servo motors, how to control them, and how to interface them with Arduino IDE using motor control units in evive with the help of an Arduino IDE sketch.
Controlling Servo Motor

Servo Sweep using Arduino IDE

In this tutorial we will sweeps the shaft of a RC servo motor back and forth across 180 degrees using Arduino IDE.

Documentations

evive Servo Fritzing circuit diagram

Servo Motor

Introduction A servo motor is a rotary actuator that allows for precise control of angular…
Set servo angle

set servo on () to () angle

The block sets the servo connected to the PWM pin to the specified angle between 0 to 180.